1 x Ceramic/Induction Hob Epoxy Repair Putty. Gloss Black. Ideal For Repairing Chipped & Damaged Edges. 38g

This is a high quality, two-part epoxy repair putty - Black.

This kit is specifically formulated for repairing chips and similar damage to induction hobs.

The putty is fully waterproof once cured.

When cured, this product is heat resistant up to 130C.

It has excellent resistance to all household cleaners.

This product will repair damage up to: 12cm Long x 4cm Wide x 1cm Deep.

NOTES: This product is NOT recommended for use on cracks near / on the actual heating rings.

             May cause skin irritation, if necessary wear gloves.

Product Contents:

1 x 38g Epoxy repair Putty (Part A & Part B)

1 x 6ml Epoxy Enamel - Gloss Black

1 x Instruction Leaflet

How To Use:

1. Ensure the surface to be repaired is clean and dry.

2. Cut equal parts of part A & B to the required length for the repair.

3. For the best results, this step is very important: Mix the equal parts of A & B putty by hand until it is a uniform colour that is streak free throughout, this usually takes approximately 5 to 7 minutes of kneading / rolling.

4. Apply and press the putty firmly to the damaged area that is to be repaired immediately, filling and shaping the putty to suit the damaged area as required. (PLEASE NOTE: The working time is approximately 15 minutes).

5. Keep your fingers and tools moistened with clean water in order to better shape and smooth the putty.

6. To obtain a smooth finish immediately gently wipe and smooth the putty with a wet finger or tool to the shape required.

7. Leave to fully cure, approximately 3 – 4 hours.

8. Clean all tools immediately after use with water.

9. When the putty is cured apply a thin coat of the Epoxy Enamel using the brush in the bottle and leave to dry for 2-3 hours.

10. If required, apply a second thin coat of the Epoxy Enamel and leave to dry overnight.

11. Please ensure that you apply the Epoxy Enamel to the Epoxy Putty only and not on to the surrounding area.